Error and fallacy of tanis eager workmanship
Error and fallacy of tani's eager workmanship
Although compared with the traditional mold, the mold has many obvious advantages, but mold users also need to understand the error of mold.To sum up, there are the following points.
1. Mould cost increases
The price of hot components inside the mold is more expensive than the force, yiwu rub wire board inside the mold hot mold cost will increase substantially.If the product added value is low, product output is not high, on the mold manufacturers are not cost-effective.For many die users of the degree of growth in China, the cost of the hot mold system is one of the most important problems affecting the use of hot mold.
2. High requirements for in-mold hot mold construction process and equipment
In - mold hot mold requirements for close processing machine as a guarantee.Mold hot system and mold integration and common requirements are extremely harsh, otherwise the mold in the production process will appear many serious problems.For example, the installation hole of the mold cylinder plane processing rough sealing parts can not seal the oil so that the cylinder can not move, anhui rubbing plate cutting knife and mold kernel together due to the lack of good cutting knife stuck unable to produce.
3. Operation maintenance is huge
Compared with in-mold hot mold, in-mold hot mold operation maintenance huge.Harbin twist wire board such as the use of improper control is easy to destroy the mold hot parts, so that the production can not stop, the formation of a huge economic loss.For r new users of hot molds, the demand for a long time to stack utilization experience.