How to smooth the surface of the object when the edge cutting die is operated?

In the mold hot mold in today's world industry countries and regions are very common use.This is primarily due to the following obvious characteristics of the in-mold hot die:

1. Take initiative to break up the mold gate and reduce the degree of dependence on people;

The product of traditional plastic mold is connected with the sprue after the mold is opened, two processes need to stop the wild shear parting, the hot mold inside the mold will break up the sprue before the mold is opened, eliminate the following processes, which is beneficial to the active production, and reduce the dependence on people.

2. Influence of low product compensation quality;

In the process of hot mold forming in the mold, the active control of sprue parting is responsible for the surface divergence of sprue parting, the result of fujian screw board is the part of character divergence, while the traditional wild parting gate technology cannot guarantee the surface divergence of sprue parting.Fenghua silk board so that the market on a lot of high quality products are produced by the mold eager mold.

3. Low molding cycle, improve production invariance

In-mold hot forming initiative, to stop the production process of useless compensation action, changsha rolling board and the product of the fully active machine shear assurance quality differences, in the product of a wide range of production process than the traditional mold has no imitativeness.